Polycom Webcam RMX 2000 Bedienungsanleitung PDF herunterladen (Seite 23)

Polycom RMX 2000 Hardware Guide

1-17

Replacing the Fan Drawer

Three fans are mounted in the Fan Drawer, where the airflow is from right

to left. Should one of these fans fail as indicated by a Fan LED, you are

required to replace the fan drawer.

1 Unscrew the screws on the front panel of the RMX 2000 that secure

the Fan Drawer.

2 Use the metal ejectors to pull the Fan Drawer out of its slot in the

Backplane.

3 Carefully slide the Fan Drawer out through the front panel.

4 Slide in the replacement Fan Drawer.

5 Push the Fan Drawer firmly into the Backplane, making sure it is

properly seated in its slot.

6 Ensure that the metal ejectors are fully retracted into their housings.

7 Tighten the screws on the front panel of the RMX 2000 that secure the

Fan Drawer.

Warning!

The Fan drawer can be replaced when the RMX unit is ON, however a

replacement drawer must be inserted immediately. The temperature increase is

detected by the system, when critical, a system shutdown is initiated.

1 2 ... 18 19 20 21 22 23 24

Keine Kommentare

Polycom Webcam RMX 2000 Bedienungsanleitung Seite 23