Polycom DOC2238A Bedienungsanleitung Seite 40

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 160
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 39
Chapter 2 - Hardware Installation
2-20
Connecting the MGC+100 to the Network
To connect the MGC+100 to the ISDN network or T1-CAS Network:
Connect the 8-pin RJ-45 connector of the network cable to the NET
RJ-45 jack on the rear panel of the MGC+100. Repeat this step for each
of the ISDN network lines to be connected to the Network Interface card
installed in the MCU.
Figure 2-9: ISDN network connection
Leased lines should be connected using an adapter with a screw
connector with solid conductor wires or a similar adapter.
Connect one side of the adapter to the NET RJ-45 jack on the rear panel
of the MGC+100. Then connect the leased line wires to the other side of
the adapter.
The ISDN network is optional. If the MGC+100 has to be connected to the public
ISDN network then an external CSU or similar equipment is needed.
T1-CAS network is optional. It allows you to connect Audio Only participants to
conferences via T1-CAS lines. It uses the same network connections as ISDN
and the procedure described below is applicable to both ISDN and T1-CAS
lines.
ISDN network
connection
ISDN Network connection
for 4 spans
ISDN Network connection
for 8 spans
The ISDN and T1-CAS network properties must be defined in the Network
Services. For details, see the MGC+ Administrator’s Guide, Chapter 3.
Seitenansicht 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 159 160

Kommentare zu diesen Handbüchern

Keine Kommentare