Polycom Telephone RMX 2000 Bedienungsanleitung PDF herunterladen (Seite 24)

Chapter 1- Hardware Description

1-18

Replacing the Power Supply Drawer

A single supply unit powers the RMX 2000. Use the following procedure

to replace a Power Supply:

1 Ensure that power switch to the RMX 2000 is turned OFF (O).

2 Unscrew the captive screws on the front panel of the RMX 2000 that

secure the Power Supply.

3 Use the metal ejector levers to pull the Power Supply Module out of

its slot in the Backplane.

4 Carefully slide the Power Supply Module out through the front

panel.

5 Slide in the replacement Power Supply Module.

6 Push the Power Supply Module firmly into the Backplane, making

sure it is properly seated in its slot.

7 Ensure that the metal ejector levers are fully retracted into their

housings.

8 Tighten the captive screws on the front panel of the RMX 2000 that

secure the Power Supply Module.

9 Turn ON the RMX 2000.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Polycom Telephone RMX 2000 Bedienungsanleitung Seite 24