Polycom 4300T Bedienungsanleitung PDF herunterladen (Seite 46)

User Guide V

IU 4300T Converged Network Appliance

3 - 28

6. Enter the TFTP Server Address. This address is used to identify the TFTP

server that contains the images used by IP phones at boot up. The 4300T

performs a TFTP server relay function.

7. Automatic MGCP Re-registration is used to re-register MGCP endpoints

every time the network or system restarts. Enable this feature to

automatically synchronize the softswitch and phones immediately after a

restart. The default is Enabled.

8. The MGCP Re-registration Rate is used to set the number of MGCP RSIP

messages to send per second to the Media Gateway Controller when

re-registration is needed. If the MGCP Re-registration Rate needs to be

changed, enter a value between 1 and 5. Generally, this value does not

need to be modified. The default value is 5 msg/second.

9. The system re-registers clients when it starts up. If any of these

re-registration requests fail, the system will wait for the configured

number of seconds and then retry the re-registration for the clients that

failed. The system will make at most 10 re-registration requests for failed

attempts. If the MGCP Re-registration Retry Delay needs to be changed,

enter a value between 30 and 60 seconds. Generally, this value does not

need to be modified. The default value is 30 seconds.

10. The H.323 TerminalType is used to specify the type of terminal that the

Voice Appliance should use. It can be either endpoint or gateway. The

Maximum Bandwidth specifies the bandwidth to allow for H.323 calls.

Note

It is not necessary to program in an FTP server address if your IP phones use the

FTP protocol instead of TFTP to retrieve their images. A relay function is not

needed for FTP as the 4300T will forward FTP traffic to the destination server as

programmed in your IP phone.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 117 118

Keine Kommentare

Polycom 4300T Bedienungsanleitung Seite 46