Polycom 4300T Bedienungsanleitung PDF herunterladen (Seite 116)

User Guide V

IU 4300T Converged Network Appliance

Regulatory Notices - 12

(1) This device must only be connected to the T1 WAN network.

(2) Before connecting your unit, you must inform the telephone company of

the following information:

Port ID REN/SOC FIC USOC

T1 WAN 04DU9-DN, 04DU9-BN 6.0N RJ48C

(3) If the unit appears to be malfunctioning, it should be disconnected from

the telephone lines until you learn if your equipment or the telephone line is

the source of the trouble. If your equipment needs repair, it should not be

reconnected until it is repaired.

(4) If the telephone company finds that this equipment is exceeding tolerable

parameters, the telephone company can temporarily disconnect service,

although they will attempt to give you advance notice if possible.

(5) Under the FCC Rules, no customer is authorized to repair this

equipment. This restriction applies regardless of whether the equipment is in

or out of warranty.

(6) If the telephone company alters their equipment in a manner that will

affect use of this device, they must give you advance warning so as to give you

the opportunity for uninterrupted service. You will be advised of your right to

file a complaint with the FCC.

(7) In the event of equipment malfunction, all repairs should be

performed by our Company or an authorized agent. It is the responsibility of

users requiring service to report the need for service to our Company or to one

of our authorized agents.

INDUSTRY CANADA (IC) NOTICE

NOTICE: This equipment meets the applicable Industry Canada Terminal

Equipment Technical Specifications. This is confirmed by the registration

number. The abbreviation, IC, before the registration number signifies that

registration was performed based on a Declaration of Conformity indicating

that Industry Canada technical specifications were met. It does not imply that

Industry Canada approved the equipment.”

Before installing this equipment, users should ensure that it is permissible to

be connected to the facilities of the local telecommunications company. The

equipment must also be installed using an acceptable method of connection.

The customer should be aware that compliance with the above conditions may

not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative

designated by the supplier. Any repairs or alterations made by a user to this

equipment, or equipment malfunctions, may give the telephone

communications company cause to request the user to disconnect the

equipment.

1 2 ... 111 112 113 114 115 116 117 118

Keine Kommentare

Polycom 4300T Bedienungsanleitung Seite 116